Photo to the left shows all that is included in one Ratchet Tie Down Strap. Twisted Snap Hooks. Short Wide Handle Ratchet. Choose either our 505-C8 or 500-C8 below. Both are the same except for load limits.
500 C8 Assembly Width: 2" * Strap Length: 8' * Breaking Strength: 10,000 lbs. * Working Load Limit: 3,333 lbs Sorry Out of Stock.
color:
505 C8 Assembly Width: 2" * Strap Length: 8' * Breaking Strength: 5,000 lbs. * Working Load Limit: 1,666 lbs. Sorry Out of Stock.
OPERATING INSTRUCTIONS
Hooks, webbing and ratchet must be in line with load force.
Pull out web slack. Pump handle to snug webbing tight. For secure hold, ratchet reel must have two layers of webbing wound around it.
Too Many layers of webbing will jam ratchet. If this happens, start procedure again removing more slack and webbing.
When being used to secure a vehicle to a trailer, lock handle down flat for transit. Tighten to secure. Once secure, the vehicle should not move.
To release, compress release bar and rotate ratchet 180 degrees.
Vehicle tires should be checked. Put vehicle in gear and set brake.
FOUR tie downs are REQUIRED. Place one at each corner of the vehicle.
Secure hooks to suitable eye-bolt on transporter frame with sufficient strength for extreme tie-down stress.
Pass webbing over vehicle frame or axle. Wrap a rag around webbing to protect sharp edges, unless you are using one of our axle straps (which have a protective covering).
Sorry Out of Stock.